WTB 5sp Driveshaft

[Buttasc0ttch]

So I finally got my 5sp conversion done, but the driveshaft that was used for the conversion is not in tip top condition. Something is wrong with the bearings, The car runs fine it just makes an annoying noise from 1-2-3. If anybody has a good used driveshaft, or just the bearing part that I need. Let me know ASAP.


1991 KA Driveshaft.
or SR20 driveshaft (lighter)

-it doesn't matter.

[JigokuZ]

are you sure it's the driveshaft and not the transmission?

[Buttasc0ttch]

well the people that did my conversion said it was the driveshaft, a few bearings messed up + rubber lining was worn out. I trust them since they are a reliable company, even here on Ziliva, but if you might think its the tranny can you give me more insight on how I would be able to tell?

[JigokuZ]

The bearing they're talking about is most likely the center support bearing. But with something like a center support bearing. It would make noise as long as it's turning. It just sounds kinda weird that it would only make noise when it's in 1,2,3 gears... and the noise should get louder or more annoying as driveshaft speed increases...

[Buttasc0ttch]

So do you have a bearing support center for sale? :x:

[JigokuZ]

I have the whole drive shaft.. but I'm selling it with the 5 speed swap package..

[ka24deturbo]

I have two driveshafts from a couple of swaps if you want one make me an offer, I'm in Las Vegas........