importsaint
09-16-2005, 12:51 AM
1993 240sx SE 5-speed HB
Ok so about three months ago I was in a rear in collision, my front end ended up under a minivan in front of me. The car started and I drove home from the accident. When I went to start it a few days later it would not start. I replaced all the parts related to the accident (radiator, did an S13 front headlight swap, A/C condenser). I timed the car completely and it started, but when I went to give it gas it just dropped RPMs and died. The parts I have replace are my fuel pump, ignition switch, ECU(M), Camshaft Position Sensor and distributor, knock sensor, ignition control module, ignition coil, intake pipe (was cracked in accident), and starter. I am about to replace the Crankshaft position sensor, can someone give me some advice, I am getting fuel and spark too! Please someone help me!!!!
Ok so about three months ago I was in a rear in collision, my front end ended up under a minivan in front of me. The car started and I drove home from the accident. When I went to start it a few days later it would not start. I replaced all the parts related to the accident (radiator, did an S13 front headlight swap, A/C condenser). I timed the car completely and it started, but when I went to give it gas it just dropped RPMs and died. The parts I have replace are my fuel pump, ignition switch, ECU(M), Camshaft Position Sensor and distributor, knock sensor, ignition control module, ignition coil, intake pipe (was cracked in accident), and starter. I am about to replace the Crankshaft position sensor, can someone give me some advice, I am getting fuel and spark too! Please someone help me!!!!