PDA

View Full Version : Air bag light keeps blinking

shayrgob240
07-10-2005, 07:37 PM
Hey!

I have a 95 nissan 240sx w/ a rb20det that i just bought and the previous owner told me that when the engine was swapped it started blinking. How do i get it to stop? thanks!
projectRDM
07-10-2005, 09:51 PM
Reset the light, then verify again if there's a problem. Replace what item throws a code.

Or take it out.
SilviaDET
07-10-2005, 11:19 PM
this was a known issue with 95's, research it to see.

Another possability is if they disconnected the steering rack during the rb install, and some jack ass got in the car and was spinning the wheel, the clock spring could be broken, also is it the stock steering wheel?
Drunk Bastard
07-11-2005, 12:10 AM
r240na, you said in a seperate thread (as well as this one) to just remove the SRS fuse (labeled AIRBAG on the panel) to get rid of the blinking light. well it worked...but only half way. now my airbag light is constantly on, rather than blinking......do you know of a way to get it off completely.

my setup:
-drivers side airbag:intact
-passenger side airbag: intact but unplugged
-AIRBAG fuse: removed
snp_ethan
07-11-2005, 03:01 AM
i got the same problem but on a ka.... and everything is intact.. if anybody knows whawts going on it'll be nice to know.. although it doesnt particularly bother me any longer...
projectRDM
07-11-2005, 09:32 AM
r240na, you said in a seperate thread (as well as this one) to just remove the SRS fuse (labeled AIRBAG on the panel) to get rid of the blinking light. well it worked...but only half way. now my airbag light is constantly on, rather than blinking......do you know of a way to get it off completely.

my setup:
-drivers side airbag:intact
-passenger side airbag: intact but unplugged
-AIRBAG fuse: removed

I don't recall the other thread, but I'm sure I meant to remove the light itself. It's an LED, fitted to the back of the cluster with two phillips head screws. You can just take the screws out and break the circuit, leaving the bulb in place in case you ever decide you need it again.
projectRDM
07-11-2005, 09:33 AM
i got the same problem but on a ka.... and everything is intact.. if anybody knows whawts going on it'll be nice to know.. although it doesnt particularly bother me any longer...

Taken directly from above that you failed to read:

"Reset the light, then verify again if there's a problem. Replace what item throws a code. "