PDA

View Full Version : WTB: Blown SR20DET


s14turbosilvia
02-09-2005, 08:38 PM
If you have one that needs some TLC, let me know about it. I'm very interested in rebuilding one.
-ben

[email protected]

racer98
02-10-2005, 08:53 PM
what are you willing too pay and did you want the motor only w/o any thing else or did you need every thing for it but a motor with low compression ?

s14turbosilvia
02-11-2005, 02:43 PM
I would prefer a complete swap with just some bad internals...rod knock, valve lash, bad piston rings...I don't want something with a hole in the block though.

jaz
02-11-2005, 04:25 PM
I might have an S14 for you in about a month, but I need to finish swapping in the new one first. Has low compression on the middle two cylinders, leakdown test says its exhaust valves.

Also have a line on a good S13 blacktop in Detroit w/ warranty, if you are interested. At least there would be no shipping charges, since you are from K-zoo.

s14turbosilvia
02-11-2005, 06:27 PM
I'm very interested in both. Please give me more information.
I'm more interested in the blown S14 though, but the blacktop is interesting, based on what comes with both.

jaz
02-11-2005, 08:14 PM
The S14 would basically be just a long block, since I need to keep most of the parts for my car. Stuff like the harness, ecu, etc. would definately not be included.

As for the S13 blacktop, comes with manual trans, both manifolds, turbo, fully accessory drive, ecu, etc. No side mount intercooler, no igniter chip, no maf and the harness is cut. Fortunately all of those parts can be sourced easily and cheaply. Like I said, the engine does have a warranty and it is local. I'll PM you some more details.

RedSuns
02-12-2005, 05:23 PM
i have an s14 Sr20DET block that i will selling cheap. The bottom end is fine. I over revved the engine and had light contact with the valves on cylinder 2 and 4. I will sell for cheap.

01SaturnL200
02-12-2005, 06:39 PM
i have an s14 Sr20DET block that i will selling cheap. The bottom end is fine. I over revved the engine and had light contact with the valves on cylinder 2 and 4. I will sell for cheap.
how much u want shipped for that?

RedSuns
02-12-2005, 09:24 PM
how much u want shipped for that?


the shiiping would be USPS freight...i am only asking 100$ for the setup...shipping would be whatever is cheapest

01SaturnL200
02-12-2005, 10:45 PM
what comes w/ it.....

s14turbosilvia
02-13-2005, 09:07 PM
alright guys. start your own thread, or PM. If you don't have anything for THIS thread to post, do it somewhere else.

s14turbosilvia
02-16-2005, 10:44 PM
bump it up. somebody has to have one!!!!

s14turbosilvia
02-22-2005, 07:34 AM
bump it up. somebody has to have one!