MrFairlady
12-03-2019, 07:16 AM
For sale is what’s left of my Project Abandon/Part out.
https://flic.kr/p/2hUnRBN
RB25/RB26 Manual Bellhousing.
*Early (first model RB26GTR) push type bell housing
(Not pull type like all other rb26 = expensive parts,low selection.
Push type is like most all other Nissan Manuals.
$400 obo
I purchased this from Raw Brokerage. They had this in stock when I went to buy a basic RB25 bell. 100% confirm fitment.
Perfect for Using Beefy z32 trans On All RB motors.
———————————-——————-
Z32 300zx 5speed for sale
Out of my running NA 2+2 and had 0 issues. Bought the bellhousing so I could use this trans with my RBneo in my z32
Includes all sensors and shifter assy
$400
———————————————-
Brand new: XTD RB25 6puck sprung Clutch and Press plate kit + 13.5lb flywheel.
$100
Never used. These are Legit. If you “know a guy...”,or, “there is a thread on...” bullshit. These are rock solid. I needed it to get the car rolling once complete.
————————————-—————
Brand new: CX Racing GT35 turbo (t4,v-band, .68 ar,oil cooled)
Includes turbo fittings, 4” Alum intake Pipe with 4” HKS filter
These are actually good turbos if you haven’t seen one.
$200
———————————————————
1993 NA 2+2 300zx,5sp blk/blk PART OUT - CHEAP CHEAP
There is still a lot left but some parts have been taken.
Clean Black leather interior Except Driver seat.
-Full UNCUT VG30de engine wiring harness and lower harness
-Engine bay harness and fuse/relay box
-Interior fuse Junction box and harness
-Full Super clean and working A/C stuff-lines,condenser,evap,blower,hi/lo press lines,compressor fans etc.
Dash,back seat,pass seat, Arm rest,Dash Trim,rear & hatch trim,rear bumper,headlights,etc,etc
Text what you need.
All parts and car located in Charlotte/Matthews NC
7043010100
Best to Text. I’m not on this site as much to check messages.
https://flic.kr/p/2hUqjoNhttps://flic.kr/p/2hUqjnA
https://flic.kr/p/2hUqjFB
https://flic.kr/p/2hUnRBN
RB25/RB26 Manual Bellhousing.
*Early (first model RB26GTR) push type bell housing
(Not pull type like all other rb26 = expensive parts,low selection.
Push type is like most all other Nissan Manuals.
$400 obo
I purchased this from Raw Brokerage. They had this in stock when I went to buy a basic RB25 bell. 100% confirm fitment.
Perfect for Using Beefy z32 trans On All RB motors.
———————————-——————-
Z32 300zx 5speed for sale
Out of my running NA 2+2 and had 0 issues. Bought the bellhousing so I could use this trans with my RBneo in my z32
Includes all sensors and shifter assy
$400
———————————————-
Brand new: XTD RB25 6puck sprung Clutch and Press plate kit + 13.5lb flywheel.
$100
Never used. These are Legit. If you “know a guy...”,or, “there is a thread on...” bullshit. These are rock solid. I needed it to get the car rolling once complete.
————————————-—————
Brand new: CX Racing GT35 turbo (t4,v-band, .68 ar,oil cooled)
Includes turbo fittings, 4” Alum intake Pipe with 4” HKS filter
These are actually good turbos if you haven’t seen one.
$200
———————————————————
1993 NA 2+2 300zx,5sp blk/blk PART OUT - CHEAP CHEAP
There is still a lot left but some parts have been taken.
Clean Black leather interior Except Driver seat.
-Full UNCUT VG30de engine wiring harness and lower harness
-Engine bay harness and fuse/relay box
-Interior fuse Junction box and harness
-Full Super clean and working A/C stuff-lines,condenser,evap,blower,hi/lo press lines,compressor fans etc.
Dash,back seat,pass seat, Arm rest,Dash Trim,rear & hatch trim,rear bumper,headlights,etc,etc
Text what you need.
All parts and car located in Charlotte/Matthews NC
7043010100
Best to Text. I’m not on this site as much to check messages.
https://flic.kr/p/2hUqjoNhttps://flic.kr/p/2hUqjnA
https://flic.kr/p/2hUqjFB