Edyz7s
01-23-2019, 01:55 PM
As easy as it should be to install, why tf am I having trouble setting it on right?
I either install it where its too retard and I advance it max and its not at 20btdc. Or its installed too advance and I retard it max and sits close but not at 20btdc.
I follow the few diagrams out their online and tried every way possible, still no luck. I match up the pin/dowel to the groove on the shaft, doesn't start. I set it a tooth forward and backward and same results. I only get it running without lining the marks by just playing with it.
Yes i set it to tdc on #1 compressed cylinder.
Yes I should of marked everything with the old distributor on prior.
It doesn't help out that the rotor has 3 ways on sitting in the distributor, that's what also throws me off.
I either install it where its too retard and I advance it max and its not at 20btdc. Or its installed too advance and I retard it max and sits close but not at 20btdc.
I follow the few diagrams out their online and tried every way possible, still no luck. I match up the pin/dowel to the groove on the shaft, doesn't start. I set it a tooth forward and backward and same results. I only get it running without lining the marks by just playing with it.
Yes i set it to tdc on #1 compressed cylinder.
Yes I should of marked everything with the old distributor on prior.
It doesn't help out that the rotor has 3 ways on sitting in the distributor, that's what also throws me off.