PDA

View Full Version : Painting handles?


teejayhoward
05-13-2018, 04:27 AM
I feel like an idiot for even asking, but I can't seem to find a way to pull the door handles completely apart for paint. Is there some secret, or do you just paint them as a single assembly?

anthony_240
05-13-2018, 09:55 AM
I tried to pull them apart when I wrapped mine. Couldn’t figure it out either ... looks like the pin that holds the handle together is like a rivet or something...

Good luck


Sent from my iPhone using Tapatalk

Z28ricer
05-13-2018, 11:27 AM
I’ve pulled them completely apart but it’s been a few years, yes it’s doable.

zenkicpe
05-14-2018, 08:44 AM
Base doors are easy peezy. There is a wire wrap that goes around the lock cylinder from the rear, it could be tricky to see but its just a simple wire that acts like a c-clip. There are 1 or 2 Phillips screws that need to be removed along with the 2 10mm nuts and rod clips.

Now if you have SE power doors, there is a large half moon shaped plastic piece which I assume is the motor for the power locks, I could NOT figure out how to pull that out through the door opening.

May be other members had more luck than I.

Good luck.