CoryDangah
04-13-2018, 01:33 PM
Hello All,
I was hoping for advise from the community on this one.
Background:
I have been tracking my 2006 350Z for around a year, and I have low compression (150psi) on at least two cylinders and 25% leak on at least one.
I am going to be tearing off my intake manifold and valve covers to isolate the leak to either the rings or the valve/seals (air was leaking from oil fill cap).
In any case, I am expecting to have to do some engine work and I would like to get the communities recommendations on good machine shops that provide quality machining and preferably, are familiar with VQ's.
I prefer NorCal but will drive to SoCal if needed.
Your help is greatly appreciated and I thank you ahead of time.
I was hoping for advise from the community on this one.
Background:
I have been tracking my 2006 350Z for around a year, and I have low compression (150psi) on at least two cylinders and 25% leak on at least one.
I am going to be tearing off my intake manifold and valve covers to isolate the leak to either the rings or the valve/seals (air was leaking from oil fill cap).
In any case, I am expecting to have to do some engine work and I would like to get the communities recommendations on good machine shops that provide quality machining and preferably, are familiar with VQ's.
I prefer NorCal but will drive to SoCal if needed.
Your help is greatly appreciated and I thank you ahead of time.