SAFC II wont hot start

[Pygmy240sx]

Installed SAFC II and everything was good. started right up and street tuned it.
went home turned off the car and when i tried to turn it back on it would crank and flood the engine. it will cold start every time. and wont start after 30 mins of driving.

I can unplug the safc II and it will start right up even when hot. but the car wont idle (idk if this is normal)

s13 Sr20det, 13 psi t25, FMIC, 3 inch Exhaust, 255lph Fuel pump. everything else is stock.

any ideas what i can do? when i unplug the safc 2 the car will not idle or rev pass 2500rpm

[[email protected]]

what are your low throttle settings?

[Pygmy240sx]

what are your low throttle settings?

:-/
low throttle at 800 is set to 2 ( should i bring it down?) goes to 4 being the highest at 7k rpms (even though i shift at 3.5k at low throttle)
http://i.imgur.com/I6QBXBu.jpg
http://i.imgur.com/M9aQmbE.jpg
http://i.imgur.com/pn3v330.jpg

[Pygmy240sx]

then throttle sensor is set to low being 35% and 75% being high

[Pygmy240sx]

what are your low throttle settings?

:-/
low throttle at 800 is set to +2 ( should i bring it down?) goes to +4 being the highest at 7k rpms (even though i shift at 3.5k at low throttle)
http://imgur.com/M9aQmbE
http://imgur.com/I6QBXBu
http://imgur.com/pn3v330