PDA

View Full Version : RB25 Oil Filter Housing


Billcriss
05-25-2017, 08:27 PM
So when pulling my motor I seem to have busted my oil pressure sending unit off my oil filter housing. Snapped the adapter into he housing. So now I need a new one.... or do I even need to run one? I've heard there are other options. I'm not trying to run an oil cooler or anything. So can I just screw my filter onto the block? Or do I need this housing


Sent from my iPhone using Tapatalk

Billcriss
05-25-2017, 08:28 PM
https://uploads.tapatalk-cdn.com/20170526/6fde8ff62704bafd7a7772087b3716a5.jpg


Sent from my iPhone using Tapatalk

smoked240
05-25-2017, 10:03 PM
Don't need if you remove the cooler. I pulled mine and works fine.

Billcriss
05-26-2017, 02:32 AM
Don't need if you remove the cooler. I pulled mine and works fine.



So what did you do with the lines ?


Sent from my iPhone using Tapatalk

smoked240
05-26-2017, 06:00 AM
So what did you do with the lines ?


Sent from my iPhone using Tapatalk

When I received my engine those lines running to the cooler block you posted, were gone. So I never had to deal with the lines.

Locate the other end of the lines and you'll have to go from there, either recirculate them together or delete them and cap where they connect.
I'd assume they run from from water pump to the cooler then from cooler to cooler block and back to the radiator or something like that, don't quote me cause I'm going off past engines.
Good luck!