PDA

View Full Version : FL 1989 RX7 V8 Project $3500


LaMaR-
03-06-2017, 08:36 AM
Ive got a 1989 Mazda RX-7 Ford 5.0 and T-5 swapped car that I've been building. Currently the car is fully tubbed in the front and the motor and trans are installed as well as the driveshaft and T2 rear end. Below I will post a bunch of photos of the car but keep in mind that the exterior bodykit pieces are not included. I will try to make a list of everything that is done to the car though.

$3500 Or best offer
Jacksonville Florida
Jon - 607-296-8619

INTERIOR
The interior that I have is complete as far as I know. The dash is not cracked but it does have a few small bubbles about the gauge bezel. All interior pieces that I have for the car will be included in the sale including stock rx7 seats.

EXTERIOR
The exterior of the car is complete and will come with factory front and rear bumpers, factory fenders and a factory hood. I will also be including a set of both S4 and S5 taillights with the car. The drivers side door handle does not work at this time but I will be looking into it today.

SUSPENSION
I will be swapping the suspension off of this car to my new car so the front will be on coil overs and the rear on lowering springs. I will also be including a PBM solid front diff mount and pinion stub if its wanted. Turbo 2 rear end and axles are installed in the car currently. I will also include a complete set of Enkei RP01 wheels with the car. 17x8/9

ENGINE - (Where the moneys at I suppose)
It's a fox body 302 with x303 cam, world product heads, bbk intake and long tube headers, arp studs, bored 30 over, eagle rods, weisco pistons, world products intake manifold and 90mm throttle body. Might be chipped as well I was told. Comes with t-5 trans and will also come with msd ignition. Ive also installed a mishimoto oil cooler and will include this with the vehicle. Lastly I have had custom lines made for the powersteering pump and power steering cooler. It is plumbed and ready to go. The engine and transmission are mounted using the grannys speed shop kit and the subframe is actually spaced out from the frame for more clearance of the hood. Although the current intake manifold does not clear the hood. I will include a SN95 upper and lower if the buyer would like them.

-Ive also got both shorty long tube and shorty headers. If you want to run the long tubes I have an exhaust that will bolt up to the car.

The motor does turn over and has all applicable wiring included with the car. Its all hooked up but it does need to have the extra plugs removed if you want that clean wire tucked look. The engine harness is currently de-loomed and awaiting this to happen.

BAD
The car needs the windshield replaced and currently doesn't have a windshield installed. The windshield I received with the car was shattered so I had it removed.

The rear fenders have been cut for wide fenders that are seen in the photo. If the buyer would like to purchase these along with the car then arrangements can be made.


If you've scrolled this far without reading, here is a list of items included.
Shell including all exterior parts
S4 and S5 rear taillights
turbo 2 rear end and axels
one piece driveshaft
t5 transmission
fully rebuilt and somewhat built ford 302
full interior
full engine harness
full chassis harness x2 if wanted.
mishimoto oil cooler
custom power steering lines
custom alternator and power steering brackets
godspeed radiator
dual fans
enkei RP01 wheels.
BBK shorty and longtime headers

https://c1.staticflickr.com/9/8304/28827785031_2fb8193d43.jpg (https://flic.kr/p/KVpW9p)Rx7 project (https://flic.kr/p/KVpW9p) by J Manderville (https://www.flickr.com/photos/neiko09/), on Flickr

heads
https://c1.staticflickr.com/9/8804/28798339622_420255754a.jpg (https://flic.kr/p/KSP23W)Rx7 project (https://flic.kr/p/KSP23W) by J Manderville (https://www.flickr.com/photos/neiko09/), on Flickr

https://c1.staticflickr.com/9/8770/28798515412_2475262057.jpg (https://flic.kr/p/KSPViN)Rx7 project (https://flic.kr/p/KSPViN) by J Manderville (https://www.flickr.com/photos/neiko09/), on Flickr

https://c1.staticflickr.com/9/8867/28872336856_ba10687baf.jpg (https://flic.kr/p/KZmgRj)Rx7 project (https://flic.kr/p/KZmgRj) by J Manderville (https://www.flickr.com/photos/neiko09/), on Flickr

https://c1.staticflickr.com/9/8223/29154479776_70744fa385.jpg (https://flic.kr/p/Lqhk7q)Untitled (https://flic.kr/p/Lqhk7q) by J Manderville (https://www.flickr.com/photos/neiko09/), on Flickr

https://c1.staticflickr.com/9/8195/29128613812_5cb4640a6c.jpg (https://flic.kr/p/LnZL4w)Untitled (https://flic.kr/p/LnZL4w) by J Manderville (https://www.flickr.com/photos/neiko09/), on Flickr

https://c1.staticflickr.com/9/8137/29065063494_dddb0b9545.jpg (https://flic.kr/p/Lho3Lo)Untitled (https://flic.kr/p/Lho3Lo) by J Manderville (https://www.flickr.com/photos/neiko09/), on Flickr

https://c1.staticflickr.com/9/8688/29785456376_a85863c2f3.jpg (https://flic.kr/p/Mo3ftj)Untitled (https://flic.kr/p/Mo3ftj) by J Manderville (https://www.flickr.com/photos/neiko09/), on Flickr

https://c1.staticflickr.com/9/8570/30277092636_bc97a4f26c.jpg (https://flic.kr/p/N8u1Ny)Untitled (https://flic.kr/p/N8u1Ny) by J Manderville (https://www.flickr.com/photos/neiko09/), on Flickr

https://c1.staticflickr.com/6/5492/30320506192_1f843afd04.jpg (https://flic.kr/p/Ncjw99)Untitled (https://flic.kr/p/Ncjw99) by J Manderville (https://www.flickr.com/photos/neiko09/), on Flickr

https://c1.staticflickr.com/6/5341/31101273105_12e0ed2dbc.jpg (https://flic.kr/p/Poj9WD)Untitled (https://flic.kr/p/Poj9WD) by J Manderville (https://www.flickr.com/photos/neiko09/), on Flickr

https://c1.staticflickr.com/1/529/32196468565_8528722c87.jpg (https://flic.kr/p/R46joZ)Untitled (https://flic.kr/p/R46joZ) by J Manderville (https://www.flickr.com/photos/neiko09/), on Flickr

https://c1.staticflickr.com/1/569/32158220966_7c105f1a39.jpg (https://flic.kr/p/QZHhHC)Untitled (https://flic.kr/p/QZHhHC) by J Manderville (https://www.flickr.com/photos/neiko09/), on Flickr

https://c1.staticflickr.com/1/455/31821022340_c74d011f63.jpg (https://flic.kr/p/QtV4jd)Untitled (https://flic.kr/p/QtV4jd) by J Manderville (https://www.flickr.com/photos/neiko09/), on Flickr

https://c1.staticflickr.com/1/514/32033794390_9d5b00d54d.jpg (https://flic.kr/p/QNHz2Q)Untitled (https://flic.kr/p/QNHz2Q) by J Manderville (https://www.flickr.com/photos/neiko09/), on Flickr

If anyone wants any other photos don't hesitate to ask.
Also to make this project more appealing to any potential buyers, I do have a full chassis harness that I would be willing to sell as well as a ARC switch panel. Although these would have to be worked into the deal, I am willing to negotiate a fair price that will make both myself happy as well as the buyer.

Price as is $3500 OBO, willing to pull the wheels and T2 rear end if the buyer doesn't want them. Also taking offers. Im not sure how fair the price is so by all means if you're interested and want to make an offer please do.

LaMaR-
03-08-2017, 07:39 AM
Willing to throw in extra parts to help with the sale.

hanzbrady
03-08-2017, 08:27 AM
So, out of curiosity how much for the long block and trans?

conner22462
03-09-2017, 08:09 PM
any more pictures of the rest of the car?

LaMaR-
03-13-2017, 12:03 PM
any more pictures of the rest of the car?

Send me a text at the phone number listed at the top and I will gladly send you as many photos as you would like

jedi03
03-13-2017, 12:58 PM
That looks like a low price to me for all the work done so far...glws or finish building it and enjoy!

conner22462
03-13-2017, 06:38 PM
any more pictures of the rest of the car?
........PM'd.....

LaMaR-
03-14-2017, 08:16 PM
........PM'd.....

Conner, I see that you're in california, just want to make sure you know the cars in Florida...

conner22462
03-16-2017, 09:44 PM
Conner, I see that you're in california, just want to make sure you know the cars in Florida...

Yeah, I currently live in Georgia.