Power fc

[usafboyer041288]

Can someone clear one thing up for me. Does a power fc for a red top work on a blacktop s13. It's not a type x engine. I used a e5 ecu

Sent from my SM-G930P using Tapatalk

[[email protected]]

The E5, 63 & 62 ECU's have the same connector and pinout only difference being the Air Fuel sensor. which is a bolt on swap. what's the PowerFc part number you are trying to use?

[usafboyer041288]

So far I'll i have found are serial numbers on the side of the fc. I know I need one ending in 15 I believe. But I may just have Enthalapy retune my ecu

Sent from my SM-G930P using Tapatalk

[inopsey]

The E5, 63 & 62 ECU's have the same connector and pinout only difference being the Air Fuel sensor. which is a bolt on swap. what's the PowerFc part number you are trying to use?

air fuel sensor?????? theres no air fuel sensor with a pfc

[Kingtal0n]

air fuel sensor?????? theres no air fuel sensor with a pfc

he means oxygen sensor, the redtop used a skinny type. I have successfully used a fat-type O2 sensor on the redtop wiring/ECU, as well as a Power FC, it was a non issue despite what you might read. Just make sure you get the signal wire correct, the fat type has it in the middle I think and the redtop has it on the outside, or something like that. Just double check it, or use a 1-wire sensor (thats waht I did, autozone/pepboys $17 fat 1-wire sensor worked in both my redtop and blacktop engines to this day)