DruidAT
06-28-2016, 03:40 PM
What's up everybody? I've been lurking the forums for years but I don't post much. Wanted to show you something I've been working on. I designed and 3D printed these S14 gauge pods. It snaps into place and for extra security, you can tap the holes on the back of your radio trim to accept a an M6-0.75 screw (I think, I can't remember). It accepts 3X 52mm gauges and 3X 38mm gauges. 5 degree flush taper face.
I just wanted to see what you guys think. I actually don't have any gauges to mount up and was wondering if any of you would be willing to test it out. I'll let you keep it afterward for your help. As long as you can prove you've got both sizes of gauges to test fit them, just pay the shipping and I'll send them your way. I'd imagine they'd match the dash pretty well with some primer and SEM texture coat. Not sending out the Single DIN unit right now since it's already in my car gaugeless and I'm too lazy to remove it.
http://i63.tinypic.com/spbthh.jpg
http://i65.tinypic.com/2eyyxl4.jpg
http://i67.tinypic.com/jrsgef.jpg
I just wanted to see what you guys think. I actually don't have any gauges to mount up and was wondering if any of you would be willing to test it out. I'll let you keep it afterward for your help. As long as you can prove you've got both sizes of gauges to test fit them, just pay the shipping and I'll send them your way. I'd imagine they'd match the dash pretty well with some primer and SEM texture coat. Not sending out the Single DIN unit right now since it's already in my car gaugeless and I'm too lazy to remove it.
http://i63.tinypic.com/spbthh.jpg
http://i65.tinypic.com/2eyyxl4.jpg
http://i67.tinypic.com/jrsgef.jpg