PDA

View Full Version : PA S13 350z Axle Adapters


kunt_masha
09-18-2015, 12:57 PM
Maverick s13 / 350z axle adapters
Used for a few laps but wont work with my current setup
$140 shipped


There are a few marks in them, but work perfect.

brndck
09-18-2015, 03:29 PM
Why won't they work?

kunt_masha
09-18-2015, 05:06 PM
I couldnt widen my track enough and keep my current overs/wheels. I run 12" and 12.5" rears so it's tough to get the 21" /22.5" hub to output distance needed.

brndck
09-18-2015, 11:52 PM
you need overflanders.

burnsauto
09-19-2015, 08:23 AM
you need overflanders.

https://upload.wikimedia.org/wikipedia/en/8/84/Ned_Flanders.png

TheRealSy90
09-19-2015, 09:42 PM
Are those measurements taken from a 350z? They didn't work on my car either, but I didn't know I needed a specific trAck width. My car was just slammed.

kunt_masha
09-20-2015, 07:39 AM
Are those measurements taken from a 350z? They didn't work on my car either, but I didn't know I needed a specific trAck width. My car was just slammed.

Yea it's just the axle lengths uncompressed. To run them you should be really low, run 0 camber, and push track width out

TheRealSy90
09-21-2015, 09:34 AM
Yea it's just the axle lengths uncompressed. To run them you should be really low, run 0 camber, and push track width out

Well I had 2 out of three. But I was told they would work on the factory s13 track width unfortunately. I was at 0 camber tucking rim on 17's. I've still not figured out what setup will work at that height.