PDA

View Full Version : Bypassing factory amps


SpankNut
08-22-2004, 11:23 AM
ya i've already looked at this and i woulda replyed but the thread looked kinda dead. but with this faq:

http://www.zilvia.net/f/showthread.php?t=10025

what do i do w/
9 * * * * *Blue * * * * * * * *acc.
10 * * * *Green/red * * * on/off
19 * * * *Blue * * * * * * * *acc
20 * * * *Green/red * * * on/off

do they still need to be hooked up to the amp or can i just leave it w/o it? Cuz i just wanna stick wires in the plug tip so i can always put it back.

kazuo
08-22-2004, 04:25 PM
The only wires you need are the ones stated in the FAQ.

Your speakers have a positive lead and a negative lead. That's all you need.

AlligatorBling
08-22-2004, 04:42 PM
Are you putting new speakers in to replace the stock ones? I'm assuming so. Just route your own speaker wire of better quality and take the factory amps out. Thats what i did.

projectRDM
08-22-2004, 07:09 PM
Ignition and remote leads can be left taped up, you don't need them plugged in.

And use the OE wire, it's plenty good enough for anything you might do unless you're planning to push 200-300 watts to them. Larger speaker wire will only add resistance.

Muzzy
08-23-2004, 11:21 AM
lol who dont you jus redo your wiring. tear that factory amp shit out!! u can use better and larger wire allowing u to run more power if u like.