Tom N
06-21-2015, 12:38 PM
Can anyone tell me what the flywheel step should be on a SR20det?
Long story short I had to replace my flywheel which was a Toda with a new one due to bad teeth on the ring gear.
Car has a spec stage 3 6 puck in it. Car shifted perfectly on this clutch and the previous clutch set up. Forget the brand of that one. Some JDM brand.
Anyways pulled the trans and simply replace the fly wheel with a Comoetiton Clutch light weight flywheel ( it matched the weight of the Toda )
Now the only way to get the car in gear withy it runnin is to adjust the master out so far that when in first gear and the clutch pressed the car will slowly start to roll forward. Once going it shifts fine to other gears. But if I adjust the pedal so it's not engaging with the clutch pressed it won't go in gear at all at a stop.
System was bleed even though it was never open in the swap. And I see the fork move properly. So I'm thinking the step is off.
Long story short I had to replace my flywheel which was a Toda with a new one due to bad teeth on the ring gear.
Car has a spec stage 3 6 puck in it. Car shifted perfectly on this clutch and the previous clutch set up. Forget the brand of that one. Some JDM brand.
Anyways pulled the trans and simply replace the fly wheel with a Comoetiton Clutch light weight flywheel ( it matched the weight of the Toda )
Now the only way to get the car in gear withy it runnin is to adjust the master out so far that when in first gear and the clutch pressed the car will slowly start to roll forward. Once going it shifts fine to other gears. But if I adjust the pedal so it's not engaging with the clutch pressed it won't go in gear at all at a stop.
System was bleed even though it was never open in the swap. And I see the fork move properly. So I'm thinking the step is off.