Matt300ZXT
06-05-2015, 09:25 AM
Who wants to buy a 1JZ-non vvti maintenance kit? I bought all these parts for my 1JZ and won't ever use them.
They're new, but some of them were installed, but never run. The motor has been sitting on my stand. I bought all these parts from Driftmotion. They are:
OEM water pump (was installed)
Thermostat
Hydraulic tensioner (was installed)
Idler pulley (has a lil flash rust in a spot from sitting but can be scrubbed off)
Timing belt (was installed)
NGK plugs
OEM gasket set (cam seals and front/rear mains were installed)
There are a couple small gaskets that might need a little copper spray on them to help them reseal perfectly as the raised crush line on them to help seal is flat now from being used. They are the gasket that goes inside the oil pan on the pickup/strainer, and the gasket that goes on the water pump housing where the long tube that goes around the motor bolts on. I probably even still have the o-rings that seal the water pump back plate to the block and the oil pan to the flange.
That's $550.57 plus shipping I paid Driftmotion for all that. I'll sell it for $425. If you bought an imported 1JZ and want to give it a fresh bill of health before using it then this is what you need.
Also, the head/block is basically what it sounds like. I bought a motorset from a guy, long story short, the head is off (just needs a good cleaning and a good valve job) and the rods/pistons are out. The engine spun over by hand without problems and all the bearings look great. I have pictures of the bores and all bearings as I was removing them and the cam/caps/buckets were all removed and stored in order of removal. It comes with an auto trans, power steering pump, alternator, starter, the intake side stuff and Driftmotion lightweight pulleys. I'll take $500 for all of that.
I'm in Chattanooga, TN so you can come pick up the big stuff or I'll ship the other stuff.
They're new, but some of them were installed, but never run. The motor has been sitting on my stand. I bought all these parts from Driftmotion. They are:
OEM water pump (was installed)
Thermostat
Hydraulic tensioner (was installed)
Idler pulley (has a lil flash rust in a spot from sitting but can be scrubbed off)
Timing belt (was installed)
NGK plugs
OEM gasket set (cam seals and front/rear mains were installed)
There are a couple small gaskets that might need a little copper spray on them to help them reseal perfectly as the raised crush line on them to help seal is flat now from being used. They are the gasket that goes inside the oil pan on the pickup/strainer, and the gasket that goes on the water pump housing where the long tube that goes around the motor bolts on. I probably even still have the o-rings that seal the water pump back plate to the block and the oil pan to the flange.
That's $550.57 plus shipping I paid Driftmotion for all that. I'll sell it for $425. If you bought an imported 1JZ and want to give it a fresh bill of health before using it then this is what you need.
Also, the head/block is basically what it sounds like. I bought a motorset from a guy, long story short, the head is off (just needs a good cleaning and a good valve job) and the rods/pistons are out. The engine spun over by hand without problems and all the bearings look great. I have pictures of the bores and all bearings as I was removing them and the cam/caps/buckets were all removed and stored in order of removal. It comes with an auto trans, power steering pump, alternator, starter, the intake side stuff and Driftmotion lightweight pulleys. I'll take $500 for all of that.
I'm in Chattanooga, TN so you can come pick up the big stuff or I'll ship the other stuff.