Lej
03-15-2015, 11:16 AM
So I have a couple of different questions.. I'll start with the one I could probably just Google, but just curious for new opinions.. I spilt some coolant on my radiator while it was hot, and it left some nasty spots.. What's the best way to go about cleaning that up?
http://i.imgur.com/6sMztTZ.jpg
I also spilt some oil on my exhuast manifold which burned up and left some spots.. What to use on that?
http://i.imgur.com/Ftaqh5J.jpg
Also I have a squeeling belt which I believe is the ac/alt belt. So I picked up a 32.5" belt with the same ribs so I could delete the compressor since I don't have the lines hooked up yet. Is there anything else I should be aware of? I know I might beed to adjust the alt's position a bit..
And lastely, my bov tube going to the manifold pops out under full throttle/boost.. (7psi) .. It's a little pop in connector and I think I just need to replace the o ring. But not sure on that.
http://i.imgur.com/QgpIk5s.jpg
Sorry if these have been asked before!
http://i.imgur.com/6sMztTZ.jpg
I also spilt some oil on my exhuast manifold which burned up and left some spots.. What to use on that?
http://i.imgur.com/Ftaqh5J.jpg
Also I have a squeeling belt which I believe is the ac/alt belt. So I picked up a 32.5" belt with the same ribs so I could delete the compressor since I don't have the lines hooked up yet. Is there anything else I should be aware of? I know I might beed to adjust the alt's position a bit..
And lastely, my bov tube going to the manifold pops out under full throttle/boost.. (7psi) .. It's a little pop in connector and I think I just need to replace the o ring. But not sure on that.
http://i.imgur.com/QgpIk5s.jpg
Sorry if these have been asked before!