PDA

View Full Version : Silvia Fender Retainers


XxS13xX
02-14-2015, 06:49 PM
I need some input here. I'm putting a Silvia front-end on my s13. I notice my Chucki fenders had some retainers holding the bumper and the fender together. When I bought the Silvia front the retainers weren't included. My questions is where can I purchase some Silvia fender retainer or is there any other alternatives?

AXV
02-14-2015, 09:43 PM
I think it's the same? I have silvia front swap on mine but it's been a few years since I swapped it.

XxS13xX
02-16-2015, 01:26 PM
I think it's the same? I have silvia front swap on mine but it's been a few years since I swapped it.

So you have usdm retainers?

Anyone else have something different or did the same thing ?

rat240
02-16-2015, 01:43 PM
Post a pic

XxS13xX
02-16-2015, 02:45 PM
Post a pic

It goes on back of the portion I highlighted.
http://i1055.photobucket.com/albums/s514/xS13xJDMx/BumperHighlight_zps497f1d92.png

XxS13xX
02-17-2015, 07:03 PM
Anyone? I'm not the only one with a silvia front-end

slideslidegnarslide
02-17-2015, 07:09 PM
The metal plate that has the studs welded on for the bolts on the fender? I'm not sure if they are the same I'd pull the ones off my pop up front and check. Can't hurt

corkscrew
02-17-2015, 07:39 PM
I made some out of thin home depot sheet metal and drilled some holes. Works fine

XxS13xX
02-17-2015, 07:50 PM
The metal plate that has the studs welded on for the bolts on the fender? I'm not sure if they are the same I'd pull the ones off my pop up front and check. Can't hurt

Yes, its metal plate. Thanks, I appreciate it.

XxS13xX
02-17-2015, 08:17 PM
I made some out of thin home depot sheet metal and drilled some holes. Works fine

Did you weld the studs on the piece of sheet metal?

XxS13xX
02-19-2015, 10:34 PM
The metal plate that has the studs welded on for the bolts on the fender? I'm not sure if they are the same I'd pull the ones off my pop up front and check. Can't hurt

Have you checked?