View Full Version : 98 Kouki S14 5 speed swap
thekyroshon
10-13-2014, 03:14 AM
Yes I've read all the sites on how to do it. I just need to know since I have a lower wiring harness for the 5 speed s13 tranny is there anything else I have to do with wiring besides the 2 wires to make it think it's in park at all times?
thekyroshon
10-13-2014, 09:57 AM
Id appreciate help even though this is a noob question
thekyroshon
10-13-2014, 05:08 PM
Anyone know?
iLOVEASIANGIRLSS
10-13-2014, 05:23 PM
***crickets*** this has been covered alot, search a little harder?
thekyroshon
10-13-2014, 05:41 PM
I've searched everywhere and still nothing.
Chaluska
10-13-2014, 08:02 PM
Yes I've read all the sites on how to do it. I just need to know since I have a lower wiring harness for the 5 speed s13 tranny is there anything else I have to do with wiring besides the 2 wires to make it think it's in park at all times?
nope... just cut and twist the 2 auto-tranny interlock wires and you are good to go..
http://i8.photobucket.com/albums/a44/isujinx/RBSwap/inhibitorswitch.jpg
thekyroshon
10-13-2014, 11:40 PM
Thank you!
thekyroshon
10-13-2014, 11:41 PM
do I have to push the clutch in to start it or can I start it without the clutch ?
Kouki05
10-14-2014, 02:01 AM
Starts with out clutch pushed in
thekyroshon
10-14-2014, 05:30 AM
Well I have it wired up but it won't turn over. The lights come on but I have no crank. Any ideas?
thekyroshon
10-14-2014, 05:32 AM
I also have auto ecu. And I'm using the auto starter. Do I have to use a manual one? It's the ka24de
bmaddock
10-14-2014, 07:54 AM
No you do not need a manual starter. Make sure you connected the wires to the starter again. Same thing happened to me with no crank but then just realized I left the power wire off the starter lol. Fired right up after that.
Also I didn't connect any sensor from the trans other than speed sensor and reverse lights. I'm pretty sure you need Crank Angle Sensor for S14 though. CAS is on top of the bellhousing. S13 trans do not have a hole for one so you have to either drill a hole out of the sensor on top of the bellhousing or go S14 trans. I briefly read in the thread you might not need it but could be worth looking into. Sorry I'm an S13 guy.
http://forums.nicoclub.com/s13-ka24de-transmission-conversion-for-the-obdii-s14-write-up-t384931.html
Also make sure you wired the ECU to think it's in neutral correctly.
http://www.ka24development.com/cwilfert/S14_tranny_swap_electrical.html
vBulletin® v3.8.11, Copyright ©2000-2021, vBulletin Solutions Inc.