PDA

View Full Version : GS300 2JZ swap ISSUE


Blown240sx
04-17-2014, 07:19 PM
I'm working on a guys 89 s13 240sx with a GS300 2JZ swap from a 95.

Harness is by Chasebays

Engine had a blow HG but would still start up, idle and was driven before being pulled.
HG and timing belt were both replaced. Mechanical timing is spot on all marks line up. Ignition timing is close enough it should start and run.
ECU has constant power. switch 12 and Ground on the main wires. Ive checked them all
Fuel pump is wired off the key to turn on and stay on.

Issue

The car will start and fire up. Rev on its own to about 3k then die immediately
If you pump the throttle it will sometime t ry to stay running but will die in about the same amount of time if not slightly more. No matter how fast you pump or how much gas you give it, the car will die.
I unplugged the MAF to test if it was faulty with same results.
I unplugged the TPS sensors and get the same results.

I read on other swaps to check the Igniter return wire at the ECU. Not sure what to look for if its 12v or what.

Its just really confusing how well it fires right up but then dies right away with no way to keep it running. Its almost like the Injectors or Coil stops firing.

Flipnirish
04-19-2014, 09:43 AM
Cam you pull a code from the chasebays harness? If so, I would start there. If not, check spark, fuel, and air. It really sucks starting from scratch, but it you know the theory behind engines, you should be able to figure it out eventually. Good luck!

Protius
04-19-2014, 07:05 PM
What kind of fuel pressure are you getting? Is it a stock pump or upgraded?