ms!3
03-31-2014, 03:45 PM
No trades
No part out
FT Worth Texas
$8000
http://i61.tinypic.com/2nvxc12.png
Chassis:
1991 Fastback
Single stage red (factory aztec red match)
Knock off vertex aero
s14 Ganador mirrors
Fiberglass replica kouki wing
Kouki tail lights
Oem kouki position lights
Interior:
Thrash driver seat (nams rail)
Bride zeta 2 passenger seat (bride rail)
Dmax floor mats
Nismo shift knob
Stack Pro control gauges. Oil pressure, boost and water temp
Nardi classic 330mm
Techno toy tuning 90mm extender
Sparco hub
Jdm climate control panel (not hooked up)
Suspension:
Pbm coilovers
Pbm tension rods
Pbm Rucas
Pbm subframe risers
Spl tie rod ends
Abercrombie 30mm extended Lcas (with Pegasus heim joint sway bar mounts)
Cusco strut bars(whiteline clamps)
Corner balanced alignment (I have a sheet with all of the specs)
Footwork:
Avs Model 5
17x9+22 (215/40)
18x10+19 (225/40)
Engine:
Black top sr20
Pbm hmic
Megan turbo manifold
T25 with stainless steel lines
Walboro 255 pump
Mishimoto Ka24 radiator
Circuit sports overflow
Isis dual 3in exhaust (not installed)
Off brand 3in downpipe (not installed)
Off brand screamer pipe
Isis oil cooler (not installed)
The Bad:
Car does not stay primed, takes a good 10mins to start sometimes if it has sat for more than a few hours. Could be faulty pump, I’m not sure.
Random scratches and chips in aero.
Could use a new engine harness. This one works fine, but it doesn’t fit too well, a little sloppy.
Car will bog until it reaches operating temperature. Idles fine, but doesn't really have any power until its run for a few minutes.
Missing fuses, so not everything is working properly at the moment. Lights, brakes, etc.
No speed sensor, reverse lights.
Overall it’s a great car, just needs a few odds and ends. Lots of great parts might I add. Thanks for looking.
No part out
FT Worth Texas
$8000
http://i61.tinypic.com/2nvxc12.png
Chassis:
1991 Fastback
Single stage red (factory aztec red match)
Knock off vertex aero
s14 Ganador mirrors
Fiberglass replica kouki wing
Kouki tail lights
Oem kouki position lights
Interior:
Thrash driver seat (nams rail)
Bride zeta 2 passenger seat (bride rail)
Dmax floor mats
Nismo shift knob
Stack Pro control gauges. Oil pressure, boost and water temp
Nardi classic 330mm
Techno toy tuning 90mm extender
Sparco hub
Jdm climate control panel (not hooked up)
Suspension:
Pbm coilovers
Pbm tension rods
Pbm Rucas
Pbm subframe risers
Spl tie rod ends
Abercrombie 30mm extended Lcas (with Pegasus heim joint sway bar mounts)
Cusco strut bars(whiteline clamps)
Corner balanced alignment (I have a sheet with all of the specs)
Footwork:
Avs Model 5
17x9+22 (215/40)
18x10+19 (225/40)
Engine:
Black top sr20
Pbm hmic
Megan turbo manifold
T25 with stainless steel lines
Walboro 255 pump
Mishimoto Ka24 radiator
Circuit sports overflow
Isis dual 3in exhaust (not installed)
Off brand 3in downpipe (not installed)
Off brand screamer pipe
Isis oil cooler (not installed)
The Bad:
Car does not stay primed, takes a good 10mins to start sometimes if it has sat for more than a few hours. Could be faulty pump, I’m not sure.
Random scratches and chips in aero.
Could use a new engine harness. This one works fine, but it doesn’t fit too well, a little sloppy.
Car will bog until it reaches operating temperature. Idles fine, but doesn't really have any power until its run for a few minutes.
Missing fuses, so not everything is working properly at the moment. Lights, brakes, etc.
No speed sensor, reverse lights.
Overall it’s a great car, just needs a few odds and ends. Lots of great parts might I add. Thanks for looking.