PDA

View Full Version : damn wtf!


alex.foo
03-15-2014, 04:36 PM
Just when I think I'm done
Just installed some 240/248 cams on 14 today.
Did everything proper or so I think.
All my markings lined up and everything.
So when I go and turn the engine manually by hand I feel some binding on my breaker bar.
I took out the spark plugs just to make sure it wasn't some good ol compression.
So my valves are touching the piston.
What should I go back on and double check?
Thank you for your input!

-I already double checked the torque on the cam caps

fliprayzin240sx
03-15-2014, 06:33 PM
Did you put the bottom end in TDC?

alex.foo
03-15-2014, 07:17 PM
Yes I did.

codyace
03-15-2014, 09:35 PM
If you're valves hit the piston you need to take the cams back out and reinstall them.


WIth that said, keep your fingers crossed that you didn't bend a valve too....