FS: SR23DET stroker motor/drivetrain

[hashim]

gauging interest to sell my setup, why? I am wanting to do a rb26dett setup, but only if i get what i feel is a fair price for my setup. onto the parts, this is all from/for an s15 motor

darton sleeved s15 block
BC 91mm billet crank, Manley turbo tuff I beams, custom CP 90mm pistons
ACL race bearings, ARP main and Mazworx head studs,
Power enterprise 90mm Head gasket
P&P head, new seals, dual guide conversion, (upgraded roller lifters)
BC springs, retainers, stock valves, tomei 270/270 HL cams
port match stock intake/ S13 TB
ISIS oil pan
full race twin scroll manifold, twin ext gates
twin tial 44mm gates
custom holset hx40 with 12cm twin scroll to v band
invidia down pipe
850cc sard/power enterprise injectors
greddy cold side piping, custom outlet setup for this turbo/manifold setup
hks twin plate clutch, JWT z33 clutch/flywheel, and a z33 cd008 trans
wiring specialties harness
koyo N flo radiator
AEM V1/ Map/IAT setup

made 495rwhp,4xx tq at 22psi pump gas, tuned at TDC performance mobile.... I want it all gone. like i said i want a rb26 to build now, but if the price isnt right, i am completely content with cranking the boost up some more........ i also have spare parts that will go with this complete set up, another stock bore block, another set of 90mm cp pistons, complete s14/s15 head etc.... price $8K OBO

[mystro2424]

Someone one buy this swap! This motor is a true beast I've driven and road in this thing. It was done right.

[Luvs2slide]

navarre fl?

[hashim]

yes sir, Good Ole Navarre! thanks for the rep ricky!

[turbob16ef]

If you posted this about a month or 2 ago I would have more than likely bought this.

[hashim]

Damn, I guess if it was the typical run of the mill SR it would sell by now? Please feel free to throw reasonable offers, BTW the dyno graph is with some BC 272 cams, and a gt3076r at the time, it wouldnt make anymore power, so it came off and on went the hx40, I decided to install some tomei 270/270 cams at that time too. the engine pic is how the motor is setup currently in the car. any more info you guys need please let me know!

[hashim]

Bumpity bumper!

[koukimuncher]

Someone buy this or else!

[brndck]

thats a really fucking good price for all thats included, especially considering the z trans.

[hashim]

thank you sir! just an update, bought a complete intake manifold setup, extrude honed bottom and greddy top that will be installing and redynoed. Wouldnt mind trading my setup for a built rb26 motor with stock twins...

[Ludwig]

I have a Built Rb26 set up give me a call 305 713 5887

[hashim]

i will give you a call in a few, thanks!