PDA

View Full Version : Sr20det starting problems....

S13alldayyo
10-13-2013, 07:23 PM
Okay so I semi finished putting my old swap into my new shell. I was goin to crank it to make sure it cranks fine and oil is pumping to the head (after all the wiring is done ofcourse). So, when I engage the cylinder all the way open, nothing happens. Everything work from the fuel pump to
The headlights and my ecu light turns on. I'm not getting no power to the switch on the starter that engages it, I tested it and got no voltage when I crank it , I'm using the new wiring specialties fully tucked harness. Any thing I should check that's not letting that switch get power? Thanks I'm advance guys! Need to finish my daily!


Sent from my iPhone using Tapatalk - now Free (http://tapatalk.com/m?id=1)
S13alldayyo
10-13-2013, 07:55 PM
Anyone


Sent from my iPhone using Tapatalk - now Free (http://tapatalk.com/m?id=1)
pacotaco345
10-13-2013, 08:38 PM
check the 75a fuseable link in the engine bay, if it's popped nothing works besides lights and some other survival stuff. also if it's popped recheck all your grounds before you throw a new one in there or it'll just pop again.
S13alldayyo
10-13-2013, 08:39 PM
That's fuse is good


Sent from my iPhone using Tapatalk - now Free (http://tapatalk.com/m?id=1)
jscherf92
10-13-2013, 08:43 PM
5 speed? Clutch interlock switch, interlock relay, check grounds.
Auto? Inhibitor switch, grounds.

http://www.nicoclub.com/FSM/240sx/91-94/EL.pdf

Page EL-12 is what you want
S13alldayyo
10-13-2013, 08:44 PM
Thanks!! And 5 speed


Sent from my iPhone using Tapatalk - now Free (http://tapatalk.com/m?id=1)
jscherf92
10-13-2013, 08:49 PM
no problem, i know the feeling. if the car didnt start as a 5sp theres a chance you wouldnt have a clutch switch or relay, there a few guides on how to override it with a jumper across two wires.
S13alldayyo
10-13-2013, 08:53 PM
I have that blue relay thing so I beleave it's a 5speed original


Sent from my iPhone using Tapatalk - now Free (http://tapatalk.com/m?id=1)