ka white bunny clutch

[Thedriftbadger]

Quick question. The white bunny setup i know is the d21 flywheel, but is it with a 280z(s30) or 280zx(s130) clutch? Or does it not matter? Cause they are both 240mm.. They have different part numbers but the diameter, spine size and tooth count are the same. Do they have the same bolt pattern to bolt onto the flywheel? Just want to be sure before i order.
Also does anyone know if the 280 clutch is actually stronger than the d21? It would make it easier to just run the d21.

[Thedriftbadger]

Alright i found the info so i'm just gonna post it up for future reference.
You can use a complete d21 setup, and 240sx throwout and pilot bearings
Or use a d21 flywheel with a s130 280zx turbo clutch and pressure plate, again with 240 bearings.
The latter is supposed to be stronger, but i'm not sure by how much. Supposedly the d21 will hold 400tq and the 280 will hold 450tq, but don't hols me to it. Hope someone can use this in the future cause it was a pain to find this info haha.

[S14DB]

RB flywheel and z33 clutch is more common now as the parts are easier to get.

With all the KA clutch setups available now not many people do white bunny anymore.

[Thedriftbadger]

Yea but it's more expensive. I'm trying to keep it low cost since it's just to get my car drivable for a few months before the new motor goes in.

[S14DB]

Yea but it's more expensive. I'm trying to keep it low cost since it's just to get my car drivable for a few months before the new motor goes in.

What's the difference between this and the new motor? Both KA's?

[Thedriftbadger]

What's the difference between this and the new motor? Both KA's?

new motor is 500hp with z32 trans.