Quick wire relocation question

[RanciD]

I am in the process of getting my wire harness out of the wheel well, I just want to double check to see how you guys did this.

Here is what I'm working with.

http://img.photobucket.com/albums/v140/coreyrancid/20130805_144912_zps67fd3027.jpg

So what I want to do is pull the wire harness up above the lip on the outside of the frame rail above where it is now, then put the fender back on over it right? I'm working alone right now so test fitting it is proving difficult. If that's right I'll just zip tie it up there and put it back together.

Also, about the seam at the top of the wheel well that needs to be hammered, did you guys notch it on either side first then smash it up or just go at it as is?

Thanks!

[BiG MiKE86]

http://zilvia.net/f/chat/407974-tucking-wire-harness-s13s-like-baws.html

[RanciD]

perfect, thanks a lot

[DialedLife]

Make sure you cut the plastic loom thing off, and try to hammer/push the wires flat a little. Or your fender won't fit right.