fishstix
07-22-2013, 08:02 PM
I need new ball joints , probably all four corners. I've been looking at the ones for roll center adjust but not convinced they are a good investment. Plus instead of spending the big bucks on one of these sets I have thought of buying a set of ball joints from bicknell race products and the collars they press into and re fabing some stock LAC so those BJs sit higher, how ever how can I figure out wether or not the taper on the shaft will work? Any ideas? Know anyone to do the same or similar?
Here is the link. http://bicknellracingproducts.com/downloads/2012_catalog/3.pdf
Junkyard diving tomorrow!
Here is the link. http://bicknellracingproducts.com/downloads/2012_catalog/3.pdf
Junkyard diving tomorrow!