engine stand

[Dagostino480]

i have a engine stand without any bolts the hold the motor to the arm/stand anyone know a good size to get?

[deolio]

uhhh use the tranny bolts?

[S14DB]

M10 X 1.5 thread/pitch. The length depends on the stand really. The tubes on the arms are usually the same length but can vary. Measure the length of the tube and the thickness of the flange on the block and add together. 60-70mm usually fits the bill.

[Dagostino480]

I just bought the motor not the trans haha and thanks you