HG Rebuild important parts list

[Strykermcgee]

When building a motor with a blown head gasket, what does Zilvia think about the necessity of replacing the rod bearings and main bearings as well as rings. I hear that that milk shake you get with a blown head gasket can cause your bearings to have premature failure after just replacing the HG and head bolts.

At this point I was planning to replace the following:
Head Gasket (apexi)
Head Bolts (ARP)
Main & Rod bearings (Probably ACL)
Rings
And I was planning to deck the head. whats the likelihood of the block needing to be decked upon typical HG failure?

[ShadowMan]

That deck has got to be clean. But it's not like everyone who replaces a HG gets the block resurfaced so it's posible. Just make sure it's super clean and take your time.

[s13-LBC-562]

i would change these to
1.value stem seals
2.water pump
3.thermal stat
4.radiator