jesteratc
05-06-2013, 07:00 AM
So recently i purchased a badly swapped sr20det 240sx hatch.
I've been going through problem after problem and tackled this one over the weekend.
I know this is a common problem between the sr20det and the Fake Greddy intake manifold. Or Freddy if you will.
Here's how my the bracket was set up on my car when i got it.
http://i260.photobucket.com/albums/ii13/jesteratc/92%20240sx%20Champaign%20sr20/IMG_2275_zps024f6c3c.jpg (http://s260.photobucket.com/user/jesteratc/media/92%20240sx%20Champaign%20sr20/IMG_2275_zps024f6c3c.jpg.html)
As you can see its only held on by one bolt, and not very well, the cable was rubbing all over the place and in general it wasn't very good for throttle response.
Also I've seen that if the cable is not set up properly on the bracket it can put too much torque on the shaft and snap it off inside the throttle body. Nobody wants that.
So heres what my friend came up with.
http://i260.photobucket.com/albums/ii13/jesteratc/92%20240sx%20Champaign%20sr20/20130505_102053_zpse933eb0f.jpg (http://s260.photobucket.com/user/jesteratc/media/92%20240sx%20Champaign%20sr20/20130505_102053_zpse933eb0f.jpg.html)
Throttle response is sooo much better. The cable barely rubs, and in general i'm much happier with it.
Also you can see i'm maintaining use of the s13 ka24de throttle body.
So with this bracket you can keep your s13 throttle body, and use a fake greddy intake manifold.
I've been going through problem after problem and tackled this one over the weekend.
I know this is a common problem between the sr20det and the Fake Greddy intake manifold. Or Freddy if you will.
Here's how my the bracket was set up on my car when i got it.
http://i260.photobucket.com/albums/ii13/jesteratc/92%20240sx%20Champaign%20sr20/IMG_2275_zps024f6c3c.jpg (http://s260.photobucket.com/user/jesteratc/media/92%20240sx%20Champaign%20sr20/IMG_2275_zps024f6c3c.jpg.html)
As you can see its only held on by one bolt, and not very well, the cable was rubbing all over the place and in general it wasn't very good for throttle response.
Also I've seen that if the cable is not set up properly on the bracket it can put too much torque on the shaft and snap it off inside the throttle body. Nobody wants that.
So heres what my friend came up with.
http://i260.photobucket.com/albums/ii13/jesteratc/92%20240sx%20Champaign%20sr20/20130505_102053_zpse933eb0f.jpg (http://s260.photobucket.com/user/jesteratc/media/92%20240sx%20Champaign%20sr20/20130505_102053_zpse933eb0f.jpg.html)
Throttle response is sooo much better. The cable barely rubs, and in general i'm much happier with it.
Also you can see i'm maintaining use of the s13 ka24de throttle body.
So with this bracket you can keep your s13 throttle body, and use a fake greddy intake manifold.