Need help with s14 abs

[DJMJDM]

So i just put on 300zx brakes in the front with the bleeder screws on the bottom of the calipers. When I went to bleed the brakes one of my helpers got the idea to start the vehicle while bleeding it and I blew the MC. After replaceing it I bled the brakes and we get steady flow but now when I bleed it the pedal is always to the floor and I get no braking power. My mechanic says it is the abs pump but I cant afford to buy a new one. Is it possible I bled the brakes wrong or is there a way I can just bypass the abs pump and say fuck abs. Please let me know asap.

[LuckyRPS13]

:l101:I think you have your calipers on the wrong side to start. The bleeders need to be at the top. Also if you put on a new master cylinder you need to bench bleed the master cylinder before you bleed any thing else. After that is done hook up your lines again and bleed all 4 calipers. There is no special steps needed to bleed the S14 ABS. Also unhook your ABS sensors this will disable ABS. If you want to remove the ABS system completely you will need to run all new hard lines from you BMC. If you can find a non ABS s14 in a salvage yard this would be the easy way to remove the ABS as bending all new hard lines from a parts store will be time consuming and a pain in the butt.:l101:

On a side note, if you want a working ABS pump I will have one ready to go shortly you can have it $50 shipped. I will be parting out a S14 SE I just picked up.