RB25det S2 Oil Warmer/Cooler Delete?)

[zimmm]

I am running a plenium on my rb25det Series2 and was planning on deleting the stock oil cooler/warmer as im running a sandwich plate and oil cooler

I already cleaned up the mess of coolant lines under and deleted the lines to the Stock Cooler/Warmer

Question is can i just leave it bolted up but no coolant lines to it? or can i loop the lines?

or do i have to get rid of it totally if so where do i put the sensor?

I just need a temp fix till i get a relocation kit in couple months

Thanks

[fliprayzin240sx]

I got rid of the whole block all together. Its a bad idea to run a sandwich block on the OEM oil cooler block. I ended up snapping the block snout and almost blew my engine after the sandwich block fell off after it snapped.

Run this:
Raw Brokerage Oil Filter Stud (Direct to Block) - RB20 RB25 RB26 - Raw Brokerage (http://www.rawbrokerage.com/raw-brokerage-oil-filter-stud-direct-to-block-rb20-rb25-rb26/)

And follow this:
Installing an oil cooler on an RB25DET (http://www.nicoclub.com/archives/rb25-oil-cooler-installation.html)