Dolby109
09-02-2012, 04:39 PM
Hey fellow Nissan owners. I've been out of the community a while, but I finally (after 3 years downtime) got a new SR20DET in my S13 240.
I just finished hooking everything up (except water pump, alt, PS belts) and I wanted to start it for a few seconds to make sure it would run alright.
So first turn of the key it starts and sputters for a second then dies. So I naturally try again, except now it just keeps spinning and gives a single cylinder put every rotation or two (like only one cyl is working).
Now I have all of the wiring hooked up correctly, I had an SR before and labeled every wire before I took it out. I did use old plugs, planning on changing them but I can swap to the new ones if needed. Fuel is old, but I ran a gallon or so through the line (using the fuel pump) before trying to start it.
Any other ideas for what I should look at?
I just finished hooking everything up (except water pump, alt, PS belts) and I wanted to start it for a few seconds to make sure it would run alright.
So first turn of the key it starts and sputters for a second then dies. So I naturally try again, except now it just keeps spinning and gives a single cylinder put every rotation or two (like only one cyl is working).
Now I have all of the wiring hooked up correctly, I had an SR before and labeled every wire before I took it out. I did use old plugs, planning on changing them but I can swap to the new ones if needed. Fuel is old, but I ran a gallon or so through the line (using the fuel pump) before trying to start it.
Any other ideas for what I should look at?