need help with rb20 into s14 pics of plugs unplugged

[SpoolNSlide]

Ive got to swap pretty much finished and cant get it to crank...the engine harness is a harness bought from wiring specialties and i made the trans harness...im getting fuel ive check for leaks and etc...but the car just turns over and its not getting spark. I have a few plugs that arent plugged up im hoping someone can identify as i dont remember where they went...heres pics..

the two black relays to the left came on my harness from wiring specialties now i have empty blue relay and nothing to plug in?
http://i339.photobucket.com/albums/n466/SEANCC_album/SNC01141.jpg
http://i339.photobucket.com/albums/n466/SEANCC_album/SNC01142.jpg

This plug i cant see anywhere for it to plug into at its attached to the trans harness
http://i339.photobucket.com/albums/n466/SEANCC_album/SNC01138.jpg

These two are right by the wipers...thinking one was for CC but i dont know can someone identfy?
http://i339.photobucket.com/albums/n466/SEANCC_album/SNC01111.jpg

[SpoolNSlide]

guess im on my own

[Majorwood76]

That empty blue relay just sits in my passenger side next to the ecu the one up top mine just hangs there zip tied to nothing I have nothing running to my tranny as for wiring. Double check your ignitor ground or replace the ignitor...Check coilpacks

[SpoolNSlide]

replace ignitor its fine....still no spark...figured out all plugs except one by the trans i did find out on the ka that the plug is for 4 ecu grounds, 2 oxygen heater sensors and a cps sensor its a 8 pin plug with 7 wires

[SpoolNSlide]

put my ignitor and coil on my bro's rb25 and runs his car find...cas seems to check out fine