Piggy
08-08-2012, 07:33 PM
http://i1113.photobucket.com/albums/k516/matthewcollins601/matt2.jpg
I'm not not good at saying exactly what shit is called, but hopefully the picture will help my point get across. See the gear in the middle (that runs the dizzy gear)? That bolt won't tighten any further than that (put in a smaller washer to see if it would).. The head is stripped I suppose and it just tightens forever.
http://i1113.photobucket.com/albums/k516/matthewcollins601/matt1.jpg
The bolt on the left is from the pic above ka that I just bought that was quoted to only have 20 miles on it after a rebuild and the one on the right is from my daily for comparison. I put the one on the right in and it did the same. Tightens for a bit but then I can just pull it straight out by hand.
I'm just looking for any ideas here guys. The head is fresh and I hate to trash it, but that's what it looks like is going to have to be done.
I'm not not good at saying exactly what shit is called, but hopefully the picture will help my point get across. See the gear in the middle (that runs the dizzy gear)? That bolt won't tighten any further than that (put in a smaller washer to see if it would).. The head is stripped I suppose and it just tightens forever.
http://i1113.photobucket.com/albums/k516/matthewcollins601/matt1.jpg
The bolt on the left is from the pic above ka that I just bought that was quoted to only have 20 miles on it after a rebuild and the one on the right is from my daily for comparison. I put the one on the right in and it did the same. Tightens for a bit but then I can just pull it straight out by hand.
I'm just looking for any ideas here guys. The head is fresh and I hate to trash it, but that's what it looks like is going to have to be done.