s13 Viper Alarm 5701 Help!!

[Ros7.exe]

Ok so had a buddy of mine install my viper alarm

Works fine locks doors up and unlocks fine
shock sensor works
Remote start dosnt but dont need it

now while driving it blinks 3 times
while off but DISARMED blinks 3 shorts pause then 2 short times
while ARMED blinks constaly as normal

funny thing when i disarm the car 2 way pager says the shock senor went off and a door was opened

any help?!

NOTE hood pin is not connected and dash is completely off so i have no interior pieces

[Ros7.exe]

and yes i tried searching and nothing looked through the complete manual and everything

IT IS NOT IN VALET MODE
Valet mode would mean a steady blue light not blinking
I know this because I put it in Valet mode and took it off

[KiLLeR2001]

PM Broadfield, he specializes in Viper alarms. He may be able to help you if he's not too busy.

[Ros7.exe]

Thanks alot will do

[ka4life87]

I have installed alarms for many years, sounds like he didnt connect ignition wire, especially since r/s wasn't wired. Pink wire is igniton sense, it tells the brain the igniton is turned on and will reset the brain. Everytime a zone goes off and after disarm, the led keeps flashing alerting u that a zone went off. So like i mentioned the pink wire is meant for that, to reset it. Its pink on the heavy gauge harness, or yellow on small gauge harness, cant remember on the small harness if its yellow or pink