My pass side required TWICE the amount of neg camber?

[HIGHFIVEBETA]

I just got my low offset wheels. How does my pass side require -5.6 degrees of camber and my right only -3.2 to JUST BARELY clear the fenders (very flush). That is almost twice the amount. Toe is almost within factory spec. The alignment guy says this was common on s13/14.

What should I be looking at? My subframe looks alright. Would solid bushings help center it? This is driving me bananas.

EDIT: The wheels are 18x9.5 +15 on 255 width tires

[jr_ss]

Control arms good? As in not bent...

[!Zar!]

If your subframe is off center, that would explain it.

[HIGHFIVEBETA]

If your subframe is off center, that would explain it.

How possible would this be? If its bolt in and out on several fixed studs then I would doubt this possibility but you would probably know better than I would..

[jr_ss]

How possible would this be? If its bolt in and out on several fixed studs then I would doubt this possibility but you would probably know better than I would..

Your bushings could be toast and if they are OEM then most likely they are.

[Arireese]

maybe you have one s13 control arm and one s14? idk

[HIGHFIVEBETA]

maybe you have one s13 control arm and one s14? idk

.. not at all

[AutechKouki]

Off center subframe. A buddy had same issue. Car had been involved in side accident, pushed the subframe off to one side.