Help lining up engine!!

[Jersthecool]

So I dropped the engine and tranny in and I'm using the stock tranny mount and drift freaqs engine mounts with the offseted bolts. I adjusted them so the tranny bracket and mounts and everything connected perfectly could finger tighten them in because they lined up perfectly however when I looked through the shifter hole to get the shifter part dead center I would need to move it about 1/2" towards the drivers side. Is it normal that it's a bit more towards the passenger side or do I need to keep adjusting things?

[dirtijerzi240]

im assuming the driveshaft is in?

[Jersthecool]

Problem solved. The engine actually had to be pulled to one side so it slid up and down on the slotted part on the frame.

[Kenzo]

I've learned that the best way to line an engine up in an S13 chassis is to get mad and finally tug a nut and lift the engine by hand and drop it on the mounts. Works every time after about a half hour of trying with a hoist. The car won't like you when your angry.... Hulk that bitch in place.