Relentless240
05-06-2012, 09:31 PM
I just freshly swap an sr20 in and not getting spark. Im running chase bay wiring and I got power to ecu (Opened it up no signs of burn out / smell). Ignitor chip is good so is the coilpacks, New spark plug. I check grounding (not 100% im checking right). I also turned off boost control settings on ecu since im not running the apexi boost control.
Is there an easier way to check cas without removing it?
Power fc says i have faulty / out of range sensor:
-Maf
-Tps (could be out of adjustment)
I read somewhere that on power fc if TPS is faulty / out of range
that it wont send a signal to spark being that it is wired differently than oem ecu.
Sound familiar to anyone?
Is there an easier way to check cas without removing it?
Power fc says i have faulty / out of range sensor:
-Maf
-Tps (could be out of adjustment)
I read somewhere that on power fc if TPS is faulty / out of range
that it wont send a signal to spark being that it is wired differently than oem ecu.
Sound familiar to anyone?