S14 Zenki to Kouki Cluster Swap

[InsTanCeZ]

Is there a guide or how-to anywhere for this? I've searched everywhere and can't seem to find one.

[Om1kron]

http://zilvia.net/f/archive-faqs/122266-95-96-97-98-front-end-conversion-whats-involved.html

not even a whole minute on google and it finished the rest of the sentence I was typing.

[InsTanCeZ]

http://zilvia.net/f/archive-faqs/122266-95-96-97-98-front-end-conversion-whats-involved.html

not even a whole minute on google and it finished the rest of the sentence I was typing.

Lol read again, I said CLUSTER swap, not front end swap :bash:

[Om1kron]

Sorry just trolling on through.

[InsTanCeZ]

bump... anyone?

[eek]

Your going to need the fsm for both cars. If you can locate the fsm for both the zenki and kouki you will need the cluster pin out for the wires then just cut them one by one and match them up. I did one for some guy a LONG LONG time ago. It wasn't too bad, just need to take your time. Cut one wire at a time since some of the colors are re-used.

Make sure you have the pig tails for the Kouki cluster. I really don't see the point of it, Zenki cluster is 2 circles meshed together vs the kouki is 2 separate circles for the rpm/tach. Other than that not really a HUGE deal unless your that OCD/Particular how it looks. Well unless your tryin to rock the JDM cluster for the higher redline of 500 rpm difference :rolleyes:.

BE FUKIN HAPPY I'm FEELING XTRA NICE right now.


These are for the USDM Models.

USDM kouki 97
http://img42.imageshack.us/img42/4060/kouki97.png

USDM Zenki 95
http://img33.imageshack.us/img33/9390/zenki95.png