Manual Seat belt Conv Question

[japboy06]

umm...anyone that has done this conv...without using the canadian B-pillars i think...people that used their original B-pillar but jus cut a hole out...i was wondering if u guys can show me any pics of the hole...and maybe like the measurements of ur hole? thanks...also...how did u cut it...i searched...but theres no pics of the B-pillar and thats all i wanna see...thanks for ur help

[japboy06]

actually...how bout the measurements and pics of the canadian B-pillas..thanks

[soulDistortion]

When you say hole, do you mean the one for the belt to pass through, or the bolt?

If it's for the bolt, just put the old bolt in and tighten it down far enough so it clears the panel, put the panel back on, and then see where the bolt is. You don't have to worry about messing up too badly, since the seatbelt covers the hole. BTW, make sure the hole is more of an oval shape, because of the angle the panel will be in relation to the bolt (it won't be perpendicular)

If you mean for the belt, after you get the seatbelts in place with the upper part of the b pillar trim on, just look to see where the belt falls naturally and cut a hole somewhere along that path.

It's easy if you look at it.

[S13SilviaGirl]

uhmmm
i just left the pannels off...