simon240sx
04-04-2012, 04:30 AM
Hi!
This is my set up:
CNC 412 3/4 handbrake
rear 300zx caliper
hawk hp+ pads
I have not tried my CNC handbrake on the track. My CNC is a # 412. On the internet I saw that it was a 3/4. Is that it's good for braker with two rear caliper 300ZX? I do not know. The only thing I know is that when I activate my CNC to block my rear wheels, the first action of my handbrake is not enough. But the second action is correct. I have a feeling that the handbrake cylinder is not big enough. But then I'm not on the size of CNC 3/4. This is why I wanted to know what you advice as handbrake caliper for the 300zx. I expected from you. Thanks!
This is my set up:
CNC 412 3/4 handbrake
rear 300zx caliper
hawk hp+ pads
I have not tried my CNC handbrake on the track. My CNC is a # 412. On the internet I saw that it was a 3/4. Is that it's good for braker with two rear caliper 300ZX? I do not know. The only thing I know is that when I activate my CNC to block my rear wheels, the first action of my handbrake is not enough. But the second action is correct. I have a feeling that the handbrake cylinder is not big enough. But then I'm not on the size of CNC 3/4. This is why I wanted to know what you advice as handbrake caliper for the 300zx. I expected from you. Thanks!