PDA

View Full Version : Need some help, Timing?


Vinnyboi
03-24-2012, 10:03 PM
so i blew my hg and over the last week i replaced it, Set it to tdc took it all apart replaced everything and torqued it all to spec..

now it ran before i pulled it all apart but now i cant seem to get it running after i installed everything so i need a little help...

i have the motor in tdc and i installed the distributor on cly #1 and turned it over by hand so i know non of the valves where hitting go to start it and nothing.... im getting fuel and spark check all that so im guessing somewhere i messed up on the timing? idk im confused and would really like some help
http://i245.photobucket.com/albums/gg70/vietwhitboi/Cars/120324_001.jpg
http://i245.photobucket.com/albums/gg70/vietwhitboi/Cars/120324_002.jpg

airman
03-24-2012, 10:23 PM
Cams look good, but I'd make sure your dizzy isn't 180* out.

Vinnyboi
03-26-2012, 07:04 PM
Cams look good, but I'd make sure your dizzy isn't 180* out.

either im doing something wrong or .... idk haha i tdc my engine and installed the dizzy on cly 1.. still nothing...

ultimateirving
03-26-2012, 07:35 PM
i had to restab my diz a few times to get it right.. even though i swore i was at tdc both times it still was out of timing. finally after adjusting slightly i was able to get it set right and it cranked right over

Vinnyboi
03-27-2012, 02:29 PM
http://s245.photobucket.com/albums/gg70/vietwhitboi/?action=view¤t=120326_002.mp4 (http://s245.photobucket.com/albums/gg70/vietwhitboi/?action=view&current=120326_002.mp4)
video


http://i245.photobucket.com/albums/gg70/vietwhitboi/120326_004.jpg

Well thats the way i had it... i got it to pop once then it wouldnt pop again

Vinnyboi
03-30-2012, 04:44 PM
i got the car running, but now when it warms up it dies when i shift gears,stop lights red lights and im not getting a boost or vacuum gauge just reads -4.80 im gonna clean the iacv and see if that helps

i need help car doesnt stay running after warmed up. the idle bounces and bogs out and dies

bump