drift freaq
03-20-2012, 02:09 PM
yup here they are 80 durometer track tested high quality poly urethane engine mounts. There is a link in my sig that will take you to a multipage reveiw. Lots of people here are using my mounts.
The studs do not run straight through the center of these mounts unlike other brands.
You will not get any excessive vibrations from these because of this.
You will get mounts that are better than Nismo and do not rattle your teeth.
The studs are also offset so you can adjust your engine positioning up or down 1/2-3/4 of inch.
I strongly urge you to use a heat shield or a heat wrap on the exhaust/turbo side of the engine.
Here is a Brand New set of the Greens which are the latest design. $120 picked up $136 shipped my paypal is [email protected]
http://i705.photobucket.com/albums/ww52/driftfreaq/IMG_0859.jpg
The studs do not run straight through the center of these mounts unlike other brands.
You will not get any excessive vibrations from these because of this.
You will get mounts that are better than Nismo and do not rattle your teeth.
The studs are also offset so you can adjust your engine positioning up or down 1/2-3/4 of inch.
I strongly urge you to use a heat shield or a heat wrap on the exhaust/turbo side of the engine.
Here is a Brand New set of the Greens which are the latest design. $120 picked up $136 shipped my paypal is [email protected]
http://i705.photobucket.com/albums/ww52/driftfreaq/IMG_0859.jpg