s2000 push button help please

[Trinidrift3]

hey,

i had an s2000 push button starter wired in my dc5. i sold the car and took out the button. i would like to wire it into my s13 but im not sure how to tackle this. so far i mounted the button and i know that when i turn the key the black and yellow wire on the ignition produces the volts. can anyone shine some light on how to get this working? i heard that s13's are hard to do.

my s2000 button has the red, green, and black wires on it. thanks

[Chaluska]

get wiring diagrams for both cars, match up, and be done with it.

not too hard.

standard ignitions usually have a on / start / acc

you will still need the key and ignition cylinder, and you will just use the start wires..

on the S2k, i think the green wire is illumination.. red and black should be the open and close connection in the switch

[slim]

when i googled "push button start 240sx" 39,300 results came up. first four were youtube vids. hope that helps. thats the first place i looked when this came to mind a while back. post results when you figure it out.

[Trinidrift3]

I think i got it. I'll post a diy

[waxball88]

What is the pinout on the button? I just did one (non s2k)
2 wires for starter wires
1 ground
1 12+