Replaced gearbox S14DET and no clutch

[calebs555]

Took gearbox out for repair, Put it back in and the thrust bearing was not connected to the clutch fork, I put it place, by going off my mates datsun gearbox, The clutch has been bled, but the pedal just hits the floor and stays there, the clutch fork is not engaging the slave cyclinder... Is there a certain way to attach the thrust bearing? It feels like it was done right, but i cannot be positive?

Any ideas would be much appreciated!

[matt2400]

Check that the cluch cooler line is not air bound