PDA

View Full Version : head gasket for sr20det


G-moore's s13
02-09-2012, 06:18 PM
does anyone know if the apexi headgaskets are available for the s13 sr20det's anymore. Enjuku only has cometic and er spec i believe on their site. Do any of you guys have good luck with cometic? I have assembled a few race engines for my bikes and have had cometic gaskets not seal right from the get go.

Pinggg
02-09-2012, 06:40 PM
Apexi- I use one on my built sr20det personally.
or Cosworth, both are good.

And i'm sure they still have the Apexi M.H.G just give them a call.

fliprayzin240sx
02-09-2012, 06:49 PM
If you dont plan on decking the block to match the oil pump cover...stock HG with ARP studs are the way to go.

G-moore's s13
02-09-2012, 06:53 PM
i will be having the whole block machined, checked etc. will deff. be running a metal head gasket.

fliprayzin240sx
02-09-2012, 10:15 PM
Then if you're set on running a MHG...Tomei or APex'i. Everything else sucks...

c-los13
02-12-2012, 07:30 PM
If you dont plan on decking the block to match the oil pump cover...stock HG with ARP studs are the way to go.

What do mean to match the oil pump cover? I too wanna know this

rbs14kouki
02-12-2012, 07:53 PM
big head studs (dont know the brand) , OEM HG , o-ring the block *730whp @ 32psi sr20vet*

G-moore's s13
02-12-2012, 07:55 PM
O ring the block?

fliprayzin240sx
02-12-2012, 08:19 PM
What do mean to match the oil pump cover? I too wanna know this

The oil pump covers on SRs are almost always a mm or 2 taller than the block. Designed that way to help seal the cover when you put the head on and dont leak between the cover and the head. Stock paper HG is soft enough that itll seal the difference between cover and block. MHG, not so much. Have a tendency to not seal the #1 cylinder if the front cover is too tall.