View Full Version : Problem getting Laptop to connect laptop to ECU (Nistune Questions)
lgsr20swap
01-10-2012, 05:14 PM
Hey guys cant seam to get the consult to connect to the laptop. i downloaded the nistune software and installed it correctly, device manage reconizes the consult cable thru usb but when im in nistune program i cant read the ecu. so i cant load the propper rom to the z32 ecu. i have a 91 s13 w/ rb20. have all the right wires going to the ecu. dont know what i am doing right. dont know if it matters but i bought it from someone using it on a rb25. its a type 2 board
jr_ss
01-10-2012, 06:30 PM
Do you have the ignition keyed on?
lgsr20swap
01-10-2012, 06:52 PM
tried it both way. ign on and car started
jr_ss
01-10-2012, 07:22 PM
Have you looked at the instruction manual? Perhaps there is something in the troubleshooting section that can help you sink.
GroundPerformance
01-10-2012, 09:15 PM
Might need to check your engine harness if the all Consult wires are connected to the brown dash plug.
vBulletin® v3.8.11, Copyright ©2000-2021, vBulletin Solutions Inc.