MrFairlady
12-31-2011, 05:29 PM
Ok I've been searching for some other ideas to get Press going in my engine.
Redtop SR AUTO engine (clean as a whistle from Engine Importer)
Finally got everything done to start it Finally, and theres no Oil pressure.
Very loud Clanking of course for the 3 sec's I started it. Tried 1 other time and it ran for no longer than about 8sec's.
****I Rolled the engine over w/ the CAS unplugged multiple times before initial start as well.Not My 1st time.
Cam Squirters have Nothing coming out.
I replaced a ton of gaskets (all the Essentials,Pickup & gasket torqued correctly,headgasket)Oil pan is new Moroso.
I am running also a Tomei oil block and -10 Lines to Greddy Thermo Oil adaptor to Oil Cooler.
I DO believe This Is where the problem Lies But Not 100% sure.
What Ways can I try and Feed or Prime the pump Other than Keeping everything lubed and Rolling it over.
I Guess Feeding oil to it could help but do I need to Pour into Which Hole to Feed Direct? Center Filter Bolt Or in the Surround?
http://i2.frsimg.com/images/detailed_images/Greddy_12401114_01b.jpg
any other ideas I can try to Jump start the pressure????
Even the Tensioner hasn't begun to Tighted so its clear theres no Pressure
help?
Redtop SR AUTO engine (clean as a whistle from Engine Importer)
Finally got everything done to start it Finally, and theres no Oil pressure.
Very loud Clanking of course for the 3 sec's I started it. Tried 1 other time and it ran for no longer than about 8sec's.
****I Rolled the engine over w/ the CAS unplugged multiple times before initial start as well.Not My 1st time.
Cam Squirters have Nothing coming out.
I replaced a ton of gaskets (all the Essentials,Pickup & gasket torqued correctly,headgasket)Oil pan is new Moroso.
I am running also a Tomei oil block and -10 Lines to Greddy Thermo Oil adaptor to Oil Cooler.
I DO believe This Is where the problem Lies But Not 100% sure.
What Ways can I try and Feed or Prime the pump Other than Keeping everything lubed and Rolling it over.
I Guess Feeding oil to it could help but do I need to Pour into Which Hole to Feed Direct? Center Filter Bolt Or in the Surround?
http://i2.frsimg.com/images/detailed_images/Greddy_12401114_01b.jpg
any other ideas I can try to Jump start the pressure????
Even the Tensioner hasn't begun to Tighted so its clear theres no Pressure
help?